Plywood Manufacturing Process, Quality Assurance and Certifications

Corporate Brochure 22 Pages 2 MB		Annual Report 60 Pages 358 KB

Quarterly Results		Shareholding Pattern

Investor Grievances investorservices@uniply.in

Uniply Stock

We believe the minute details are the ones that will set you apart. Attention is to be given to every detail you require - no matter how small they seem.

The products will reach you promptly without any delay. Our team is always on the look to provide importance and extreme care to all the customers. It is to be known that you are being listened to at every stage. The product offers peace of mind, assurance of quality, and of course value for money. These are nothing little at Uniply. Here every small detail is as important as the plywood we make.

The logs are removed from the pond and cut according to the production plan.

The cut logs are cooked for 12 hours at a pre-set temperature of 60-80 degrees. Cooking is done to remove starch and to kill microscopic organisms.

The cooked log is then peeled to the required thickness on the peeling machine.

The veneer is then reeled and taken to the clipper machine.

The clipping machine cuts the veneer into the required dimensions.

The dryer reduces the moisture content. Drying is done at a uniform temperature and also destroys microorganisms that may have survived the cooking process.

In house production of resin ensures uniform bonding.

Every batch of resin and plywood is tested in the well-equipped laboratory by the scientists.

Wide cross core veneer and long panel veneer are layered and glued to give the plywood greater strength and dimensional stability.

The Pre-press is unique as it expands and stabilizes the layer to give a warp-free product. It also ensures uniform spread of the specially formulated chemicals within the layers.

Each board is put separately into Indias first automatic hot-press for polymerization at a pre-set temperature. This ensures uniform density at all points in the plywood. After hot-pressing the boards are cooled for 24 hours.

The boards are trimmed horizontally and vertically. A unique technique of pre-cutting is used before the final cutting to ensure dimensional accuracy.

Surface sanding is done in an automatic wide-belt sanding machine. This gives a smooth surface to the plywood, which helps in a good surface finish required for interiors.

The plywood then comes in for the final quality inspection.

The plywood is loaded and despatched to the various destinations.